Troubleshooting - ALDI FERREX FAM 20-I User Manual

Troubleshooting

Troubleshooting
Some problems may be caused by minor faults that you can fix yourself. To do so,
follow the instructions in the following table.
If it is still not possible to resolve the problem with the multifunction tool, contact after
sales support.
Problem
The handle 17 or the
multifunction tool
cannot be assembled.
The extractor line 15
the dust extraction
adapter 18 is loose/
keeps falling off.
The multifunction tool
cannot be switched on.
The tool holder 8
does not move after
switching on the
multifunction tool.
The oscillation speed
can not be increased
or decreased.
24
Possible causes
The thread 7
The tool holder
damaged.
The extractor line or
or
the dust extraction
adapter is not properly
attached.
The On/Off switch
stuck.
The On/Off switch is
defective.
There is dirt, wood
chips or other objects
located in the gap of
the tool holder.
The multifunction tool
is defective.
The oscillation rate
preselector 5
Solution
− Always keep the thread clean
is dirty.
as described in the chapter
"Cleaning and maintenance".
− Contact the After Sales Support
8 is
of the manufacturer and have
the damaged or defective part
replaced.
− Push the dust extraction adapter
firmly onto the connecting nozzle
of the extractor line and turn it
anticlockwise to fix it in place.
− Keep the On/Off switch clean
3 is
as described in the chapter
"Cleaning and maintenance".
− Contact the after sales support
of the manufacturer and have
the damaged or defective part
replaced.
− Remove the battery and clean
the gap of the tool holder with
a vacuum cleaner if necessary.
− Please contact the after sales
support of the manufacturer.
− If necessary, clean the oscillation
is dirty. rate preselector and the gap
with a vacuum cleaner.