NTP-B112 Clean Fiber Connectors
Remove the dust cap from the fiber connector.
Step 1
Press the lever down to open the shutter door. Each time you press the lever, you expose a clean wiping
Step 2
surface.
Insert the connector into the CLETOP cleaning cassette slot, rotate one quarter turn, and gently swipe
Step 3
downwards.
Use an inspection microscope to inspect each fiber connector for dirt, cracks, or scratches. If the
Step 4
connector is not clean, repeat Steps
Insert the fiber connector into the applicable adapter or attach a dust cap to the fiber connector.
Step 5
Note
Return to your originating procedure (NTP).
Step 6
DLP-B206 Clean the Fiber Adapters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the dust plug from the fiber adapter.
Step 1
Insert a CLETOP stick swab (14100400) into the adapter opening and rotate the swab.
Step 2
Place dust plugs on the fiber adapters when not in use.
Step 3
Step 4
Return to your originating procedure (NTP).
Cisco ONS 15327 Procedure Guide, R4.0
14-22
If you must replace a dust cap on a connector, first verify that the dust cap is clean. To clean the
dust cap, wipe the outside of the cap using a dry lint free wipe and the inside of the dust cap
using a CLETOP stick swab (14100400).
This task cleans the fiber adapters.
CLETOP stick swab
None
Required
Onsite
Maintenance
1
through 3.
Chapter 14
Maintain the Node
March 2003