Suzuki Grand Vitara Service Manual page 296

1D-10 Engine Mechanical: For M16A Engine with VVT
2) Remove oil, old sealant, and dust from sealing
surfaces on cylinder head and cover. After cleaning,
apply sealant "A" to the following point.
• Cylinder head cover gasket (1) sealing surface
area (2) as shown.
"A": Water tight sealant 99000–31250
(SUZUKI Bond No.1207F)
• Timing chain cover (1) and cylinder head (2)
mating surface as shown.
"A": Water tight sealant 99000–31250
(SUZUKI Bond No.1207F)
3) Install cylinder head cover to cylinder head.
NOTE
When installing cylinder head cover, use care
so that cylinder head cover gasket or spark
plug hole gaskets will not get out of place or
fall off.
www.CarGarage.ir
4) Tightening bolts in such order as indicated in the
figure a little at a time till they are tightened to
specified torque.
Tightening torque
Cylinder head cover bolt (a): 8 N·m (0.8 kgf-m,
6.0 lb-ft)
5) Connect PCV hose (2) to PCV valve (3).
6) Connect breather hose (4).
7) Install oil level gauge (1).
I2RH0B140036-01
8) Install wire harness clamp to cylinder head cover.
9) Install ignition coil assemblies with high-tension cord.
10) Connect ignition coil couplers and clamp harness
securely.
11) Install cylinder head upper cover.
12) Connect negative cable at battery.
I2RH0B140037-01
www.CarGarage.ir
I5JB0A141007-01