Siemens SINUMERIK 840Di Function Manual page 675

Table 2-13 Effect of MD20110 $MC_RESET_MODE_MASK Bits 0 to 6
Bit 0 = 1 Bit 1 = 1
Initial setting No D, T, M
after power output on
up and tool
RESET/end selection;
of part with active
program tool
see above manage-
ment
irrelevant
Bit 0 = 0 Bit 1 = 0
Initial setting D, T, M
after power output on
up and tool
RESET/end selection;
of part with active
program tool
see above. management
irrelevant.
Table 2-14 Effect of MD20110 $MC_RESET_MODE_MASK Bits 7 to 12
Bit 7 = 1 Bit 8 = 1
Active trans- Coupledaxis
formation groupings are
is retained. retained.
Bit 7 = 0 Bit 8 = 0
Transformation Coupledmotion
according to groupings are
MD20140 deactivated.
$MC_TRAFO_
RESET_
VALUE.
Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2.10 System settings for power-up, RESET/part-program end and part-program start
Bit 2 = 1 Bit 3 = 1
If bit 0=1 and bit 6 Use active
=1, the tool offset tool or tool
of the last active offset from
tool is active after last test
POWER ON program
(irrelevant with terminated in
active tool test mode
management)
Bit 2 = 0 Bit 3 = 0
No tool offset Use active
active after tool or tool
POWER ON offset from
(no effect when last program
tool management terminated
active). before
program
testing
activated.
Bit 9 = 1
Tangential
follow-up is
retained.
Bit 9 = 0
Tangential
follow-up is
deactivated.
Bit 4 = 1
Current
plane is
retained, in
SW 5
replaced by
MD 20152
index 5
see below
Bit 4 = 0
Plane
according to
MD20150
$MC_
GCODE_
RESET_
VALUES; in
SW 5 and
higher,
replaced by
MD 20152
index 5
see below.
Bit 10 = 1 Bit 11 = 1
Not configured Current setting
synchronous for revolutional
spindle coupling feedrate is
remains active. retained.
Bit 10 = 0 Bit11 = 0
Not configured Revolutional
synchronous feedrate is no
spindle coupling longer valid.
is switched off.
Detailed Description
Bit 5 = 1 Bit 6 = 1
Current Active
settable tool offset is retained
frame is
retained, as
of SW 5
replaced by
MD 20152
index 7
see below
Bit 5 = 0 Bit 6 = 0
Frame WZK according to
according to MD20120
MD20150 $MC_TOOL_RESET_
$MC_ VALUE, MD20121
GCODE_ $MC_TOOL_PRESEL_
RESET_ RESET_VALUE,
VALUES; in MD20130
SW 5 and $MC_CUTTING_
higher, EDGE_RESET_VALUE;
replaced by Output of D, T, M to PLC,
MD 20152 depending on bit 1.
index 7
see below.
Bit 12 = 1
Modified geometry axis
assignment is retained.
Bit 12 = 0
Modified geometry axis
assignment is deleted
according to
MD 20050, depending on
MD20118 (because of
compatibility).
2-139