Siemens SINUMERIK 840Di Function Manual page 1913

DB31, ...
DBX93.3 - DBX93.4 Active motor A, B
Edge evaluation: no
Meaning The drive module (611D) returns signals to PLC stating which motor selection is currently active.
Motor selection can be used with a main spindle drive (MSD) to switch between star and delta
operation and so reduce the starting current.
The following assignment applies:
Signal irrelevant SINUMERIK 810D
for ...
Corresponding to .... DB31, ... DBX21.3 and DBX21.4 (motor selection)
DB31, ... DBX21.5 (motor selected)
Additional references /IAD/ SINUMERIK 840D Installation and Startup Guide; Chapter: SIMODRIVE 611D
DB31, ...
DBX93.5 Drive Ready
Edge evaluation: no
Signal state 1 or Feedback signal from the drive to the PLC that the drive is ready.
edge change
0 → 1
Signal state 0 or The drive is not ready.
edge change
The drive might be disabled for the following reasons (refer to Fig.):
1 → 0
•
•
•
•
•
•
•
As soon as the drive is ready for operation it is stopped (depending on the fault state either with
pulse disable or fast stop) or pulse disable is maintained during ramp up.
The interface signals:
DB10 DBX108.6 (611D ready)
DB31, ... DBX61.7 (current controller active)
DB31, ... DBX61.6 (speed controller active)
are also withdrawn.
IS "611D Ready" is not available for the 840Di when used in conjunction with the drive 611U.
NC/PLC Interface Signals (Z1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Signal(s) updated: cyclic
Signal(s) updated: cyclic
Enable terminals not energized (e.g. terminal 63 "Controller and pulse enable"; terminal 663
"Safe operating stop", terminal 64 "Setpoint enable")
Drive alarm active (e.g. motor temperature has reached switch-off threshold)
DC link voltage is too low
Drive has not yet reached cyclic operation
Hardware fault
No position measuring system is active ("parking axis" state)
I/R is not switched on
2.1 Various interface signals and functions (A2)
Detailed Description
2-49