Af-Dual Receive Function - Yaesu FT3DR Advanced Manual

AF-DUAL Receive Function

The AF-DUAL Receive Function allows reception of a radio broadcast during standby re-
ception of A-band or B-band frequency (or frequency registered to a memory channel).
When standby reception is active, no audio is heard on the standby frequency, however
if a voice signal is detected, the reception of the broadcast radio will be paused, and the
receiver frequency will be heard.
Dual Receive is a similar function. When using the Dual Receive function, every time
the transceiver checks for a signal on the specified memory channel during radio recep-
tion, the radio reception is interrupted (approximately every 5 seconds). When using the
AF-DUAL Receive Function, the radio reception is interrupted only when there is a call-
ing signal from another transceiver.
1. Set the A-band or B-band frequency for standby receive during broadcast radio re-
ception.
2. Touch [F MW]  [A.DUAL].
• If [A.DUAL] is not displayed, touch [BACK ←] to
display [A.DUAL] and then touch it.
• The AF-DUAL function is activated, and AF DUAL
" " icon will be displayed.
• Pressing the [BAND] key each time switches be-
tween the AM broadcast (middle wave band) and
FM broadcast.
3. Rotate the DIAL to tune to the frequency of the
broadcast station.
• The AF-DUAL receive function can also be used to monitor a radio frequency registered
to a memory channel or memory bank.
• Pressing [MONI] switch during radio reception, allows receiving the standby frequency.
• While listening to the radio using the AF-DUAL function, in standby receive mode, the
transceiver cannot simultaneously receive broadcasts on the AM frequency (middle wave
band) on either the band-A or band-B, and FM frequency.
z Disable the AF DUAL function
1. Touch [F MW]  [A.DUAL].
26