Sony MDS-PC3 M-crew Operating Instructions Manual page 13

5
If necessary, locate the point on the MD
to start recording from.
If you want to record on a new MD or start
recording from the end of the recorded
portion, go to step 6.
To record over from the
beginning of an existing MD
track
Press ./> repeatedly (or turn
./> on the deck) until the number of
the track to be recorded over appears.
To record over from the middle
of an MD track
Press ./> repeatedly (or turn
./> on the deck) until the number of
the track to be recorded over appears, then
press N (or NX on the deck) to start
playback. Press X (or NX on the deck),
then z at the point you want to start
recording from.
6
Press z.
The deck changes to recording pause.
7
If necessary, adjust the recording level.
For details, see "Adjusting the Recording
Level" on page 14.
8
Press N or X (or NX on the deck).
Recording starts.
9
Start playing the program source.
Operations you may want to do
during recording
To Press
x (or x/Z on the deck)
Stop recording
Pause recording X (or NX on the deck)
N or X (or NX on the
Resume recording
after pausing deck)
EJECT Z (or x/Z on the
Eject the MD
deck) after stopping recording
When you pause recording
The track number increases by one. For example,
if you paused recording while recording track 4,
the track number will be 5 when you resume
recording.
To prevent accidental erasure of
the recorded material
To make it impossible to record on an MD, slide
the record-protect tab in the direction of the arrow
(see illustration below) to open the slot. To enable
recording, close the slot.
Bottom side
of the MD
z
To play the tracks you just
recorded
Press N (or NX on the deck) immediately after
stopping recording.
The deck starts to play from the first track of the
material just recorded.
Record-protect tab
Slide in the direction
of arrow
continued
13