Removing Stubborn Soiling (Excluding The Flexiclip Runners); Stubborn Soiling On The Flexiclip Runners - Miele H 2265-1 BP Operating And Installation Instructions

Cleaning and care
Removing stubborn soiling (ex-
cluding the FlexiClip runners)
Spilt fruit and roasting juices may
cause lasting discolouration or matt
patches on surfaces. This discolour-
ation will not affect the properties of
the surface finish.
Do not attempt to remove these stains.
Only use the equipment specified.
 Baked-on deposits can be removed
with a glass scraper or with a stain-
less-steel spiral pad (e.g. Spontex
Spirinett), hot water and washing-up
liquid.
Using oven cleaners
 Very stubborn soiling on PerfectClean
surfaces can be cleaned using the
Miele oven cleaner, which must only
be applied to cold surfaces.
If the oven spray gets into gaps and
openings, a strong odour is generated
during subsequent cooking pro-
grammes.
Do not spray the oven cleaner onto
the roof of the oven compartment.
Do not spray the oven cleaner into
the gaps and openings of the oven
compartment walls and rear wall.
 Follow the instructions on the pack-
aging.
Oven cleaners from other manufactur-
ers must only be used in a cold oven
and for no longer than a maximum of
10 minutes.
 You can then also use the scouring
pad on the back of a washing-up
sponge to remove the soiling.
60
 Remove all cleaning agent residues
thoroughly with clean water.
 Dry all surfaces with a soft cloth.
Stubborn soiling on the Flexi-
Clip runners
Cleaning FlexiClip telescopic runners
in a dishwasher would remove the
special grease which is essential for
their smooth functioning.
Never attempt to clean FlexiClip tele-
scopic runners in a dishwasher.
For stubborn surface soiling or if the
bearings become sticky with spilled fruit
juices proceed as follows:
 Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid.
If necessary use the back of a wash-
ing-up sponge to remove the soiling.
The bearings can be carefully cleaned
with a soft brush.
Cleaning may cause some discoloura-
tion or fading in places, however this
will not affect the functioning of the run-
ners in any way.