Network Configuration - KMC Controls KMD-7001 Installation & Operation Manual

KMD-7001/7002/7003 Direct Digital Controller Installation & Operation Guide

Network Configuration

Programming
RJ-12 PC/NETSENSOR PORT
GND GND IN1 IN2 IN3
STE-5013
A B C
(OPTIONAL IN PLACE
OF NETSENSOR)
24" OF 1/4" TUBING
H
L
FLOW
SSS-1000
KMD-7003
Room ˚F Min 0
Max 1
6-CONDUCTOR CABLE
FLOW V. FCTR
MIN C. FCTR MAX
NETSENSOR
KMD-1151 / KMD-1171
*
For electric reheat applications, use a separate 24 VAC transformer to isolate the relay through the Triac.
Illustration 8. Typical KMD-7003 Application
Note:
Typical Application Diagrams may be obtained by contacting KMC Controls
Technical Support at 574-831-5250 or e-mail us at techs@kmccontrols.com.
Prior to operating the controller, it must be configured using the Hardware
Configuration Manager (HCM) application supplied with WinControl. Refer to
the WinControl XL User's Manual and the KMC Digital Applications Manual for
additional information.
Note:
All controllers on the same network must be configured for the same baud rate
and each controller assigned a unique address.
Refer to the KMC Digital Applications Manual for information on how to pro-
gram the controller.
KMD-7003
OUT1 T2 RET R3
COM B A GND
R
SERIES FAN
START CIRCUIT
HWR
APPLICATION DRAWING FOR KMD-7003
VAV WITH FAN AND WET REHEAT
FROM PREVIOUS DEVICE "B"
FROM PREVIOUS DEVICE "A"
TO NEXT DEVICE "B"
TO NEXT DEVICE "A"
24VAC 120VAC
W
24VAC THERMAL
*
ACTUATOR
B
HWS
H
Installation
9