Software Interface Instruction T2100-St Series Calibration - GE T2100-ST1 Service Manual

Software Interface Instruction T2100-ST Series Calibration

Tools Required
o
o
o
o
NOTE:
1.
2.
3.
4.
5.
2097937-002 Rev G
11 March 2019
Calibration Program (T2100-ST Series Calibration Software)
Chalk or some other temporary marking device
Computer or laptop (PC)
Serial or USB Communication Cable
This task needs to be performed prior to speed or elevation
calibration.
Connect the treadmill to AC power.
Connect the treadmill and PC.
o
If using USB cable, connect a USB cable (GE part
number 2044095-001) between the PC and the T2100-
ST series treadmill and turn on the treadmill.
o
If using RS232 serial cable:
a. Connect one end of the RS232 serial cable (GE part
number 2097829-109) to the RS232 COM port located
on the lower front panel of the T2100-ST series
treadmill.
b. Connect the other end of the RS232 serial cable (GE
part number 2097829-109) to a COM port on the PC.
c. Turn on the Treadmill.
Open T2100-ST Series Calibration Software by browsing for the
T2100-
file named
ST_Series_Calibration_Software.application
clicking on it.
NOTE:
This file should be found in the directory in which the
file ST_Series_Calibration_Software.Zip was unzipped.
In the lower left of the window, select the appropriate COM and
Open
press .
For example:
When connected, the numerical count to the right of
increase in value:
This is the indication that the communication has been
established with the treadmill.
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V
.
Calibration
and then double
Sent:
will
167