Epilation - Silvercrest SBT 3.6 C1 Operating Instructions Manual

Epilation

When the appliance is charged and the body part to be epilated is prepared:
1) Rub your hand once more against the growth direction of the hairs to be removed.
This will raise the hairs so that they can be better captured by the tweezers.
2) Fit the epilator head
head must be facing towards the side of the hand element
off button is located (see chapter "Fitting/removing the attachments").
3) Push the on/off switch
4) Hold the skin tight with one hand.
5) Place the appliance perpendicular to the skin and, without exerting any pressure,
move it against the direction of the hair growth. Do not make back and forth or
circular movements. Move the appliance slowly with calm and gentle movements.
Always start anew and pass over the body part to be epilated several times, so that
all of the hair is removed.
NOTE
► It is possible that some hairs will grow back after a few days. The reason for this
is that these hairs were too short to be removed during the last epilation session.
6) When you are finished with the treatment, push the on/off switch
direction to switch off the appliance.
7) Clean the epilator head
SBT 3.6 C1
(Fig. 1)
on the hand element
in the direction of the attachment.
as described in the section "Cleaning and Care".
. The slight curvature of the epilator
on which the on/
GB │ IE
(Fig. 2)
in the opposite
│
27 ■