Related Manuals for ABB i-bus 6115-24-500
Summary of Contents for ABB i-bus 6115-24-500
- Page 1 73 - 1 - 5824 22013 ® ABB i-bus UP switching sensor 6115-/16-/17- 24 - 500 for UP bus coupling unit 6120 U-500 Operating instructions only for authorized, skilled electricians with EIB training...
-
Page 2: Important Instructions
(item no. 1721) is equipped with an inspection window (fig. 1, pos. 2). You may use perforated sheets for labelling (item no. 1799). The manufacturer database of ABB is continuously supplemented and completed. It stores the latest types of applications and their related descriptions. If this database... - Page 3 Technical data / Fig. 1 Nominal voltage: Current consumption: < 10 mA Environmental temperature range: -5 to +45 °C Fig. 1 r e s...
-
Page 4: Installation
Installation Plug the application (Fig. 1, pos. 1) onto the UP bus coupling unit (pos. 4) in such a way that the 10-pin connector (pos. 6) on the rear side is not canted or tilted. The plastic webs (pos. 7) on the rear side of the application must be inserted into the relieves (pos. - Page 5 Adapt bus coupling process Assign physical address • Connect a PC equipped with the EIBA software (ETS) to the EIB bus line via an EIB-RS 232 interface. • Press the programming key at the bus coupling unit: the red programming LED will become illuminated. •...
- Page 6 Adapt bus coupling process Select application By default, the UP bus coupling unit is programmed to operate one application for the switching (1-, 2-, 4-fold) of consumers. To a 4-fold switching sensor, for instance, the following functions apply: Function green Physical address F F F F Group address...
- Page 7 Adapt bus coupling process Differentiate application Version 1 A separate group address may be assigned to the LED of the rocker switch. This address is independent from the group address which has been assigned to the switching function of the rocker. Example for application: The LED shall indicate the current switching status of an actuator which is selected via several group addresses.
- Page 8 LED which has not been assigned any function will not change its colour. If a touch contact / dimmer function is requested, the UP bus coupling unit has to be loaded with different ABB application data (applications).