Clean the undersurface of the gearunit base and the foundation frame.
Using suitable lifting gear, place the gear unit on the foundation frame.
Use only the eyes provided to attach lifting equipment to the unit.
Do not use the front threads at the shaft ends to attach slinging and lifting gear for
transport.
Tighten the foundation bolts to the specified torque (see item 6.24); if necessary, use stops to prevent
displacement.
Align the gear unit exactly with the input and output units (see item 6.3.2.1).
Record alignment dimensions, see also item 7.2.
The report must be kept with these instructions.
6.3.2.3 Fitting on a concrete foundation by means of stone bolts or foundation blocks
Clean the undersurface of the gearunit base.
Placing stone bolts:
Hook stone bolts with washers and hexagon nuts into the foundation fastening points on the gearunit
housing (see fig. 37).
The hexagon nuts must only be tightened when the concrete has set.
1
2
3
4
5
Fig. 37: Stone bolt
Placing the foundation blocks:
Hook the foundation blocks with washers and fastening bolts into the foundation fastening points on
the gearunit housing (see fig. 38).
Tighten the fastening bolts so far until the housing foot lies level on the foundation block.
The fastening bolts must only be tightened to the tightening torque when the concrete
has set.
1
2
3
4
5
9
6
Fig. 38: Foundation block
1
Hexagon nut
2
Washer
3
Gearunit base
4
Stone bolt
5
Foundation
1
Fastening bolt
2
Washer
3
Gearunit base
7
4
Set screw
8
5
Flat steel plate
6
Foundation
7
Final foundation height
8
Prepared foundation height
9
Foundation block
BA 5033 EN 03/2011
50 / 96