Error Messages/Trouble Shooting - Torqeedo Travel Series Owner's Manual

5.6 Error messages/trouble shooting

Display Cause
E02 Stator over-temperature
(motor overheating)
E05 Motor/propeller blocked
E06 Voltage in the motor too
low
E07 Motor overcurrent
E08 Circuit board overheating
E21 Tiller calibration defective
E22 Magnetic sensor defective
E23 Value range false
E30 Motor communication
error
E32 Tiller communication error
E33 General communication
error
E41, E42 Incorrect charging voltage
E43 Battery empty
E45 Battery overcurrent
E46 Battery operating tempe-
rature error
E 48 Charging temperature
error
Other error Faulty
codes
No blinking Faulty
during charge
process, no
function of tiller-
display during
charge process
What to do
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
Disconnect motor cable from battery, then loosen blockage
and turn propeller one revolution by hand. Reconnect
motor cable.
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
Continue at low output.
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
• Re-calibrate: Press "cal" button for 10 seconds.
• The display shows "cal up": Press tiller forward to full
gas then press the "cal" button.
• The display shows "cal stp": Return tiller to central posi-
tion then press the "cal" button.
• The display shows "cal dn": Press tiller backward to full
gas then press the "cal" button.
Re-calibrate (refer to E21)
Re-calibrate (refer to E21)
Check the motor cable's plug-in connection. Check the
motor cable for damage.
Check the tiller's plug-in connections. Check the cable.
Check the plug-in connections and cables. Switch the
motor off and on again.
Use a Torqeedo power supply. If the error occurs in spite
of using a Torqeedo power supply, wait untill the battery
dissipates the overcharge. Should the error persist please
contact Torqeedo Service.
Charge battery. Motor can potentially be used again slowly
from the stop position.
Switch motor off and on again. If this error occurs the
battery status indicator and range display can no longer
operate until the battery has been fully charged again.
Battery cells outside operating temperature between -20°C
and +60°C (-4°F to 140°F). The motor can be used again
when the temperature has stabilized.
Charging will continue when the cell temperature is
between 0°C and +45°C (32°F to 113°F).
Contact Torqeedo Service and notify them of the error
code.
Contact Torqeedo Service.
59