Download Print this page
Rotary Sprinter SPO15 Operation & Maintenance Manual

Rotary Sprinter SPO15 Operation & Maintenance Manual

Hide thumbs Also See for Sprinter SPO15:

Advertisement

Sprinter SPO15 (3A0 Lifts) Capacity 11,000 lbs.
Standard SPO15 (300 Series Lifts) Capacity 15,000 lbs.
Standard SPO18 (300 Series Lifts) Capacity 18,000 lbs.
SPO15 (31A0 Lifts) Capacity 14,300 lbs,

Table of Contents

Safety Instructions .............................................................................................. 2
Owner/Employer Responsibilities ..................................................................... 3
Operating Instructions ........................................................................................ 4
Maintenance Instructions ................................................................................... 6
Trouble Shooting ................................................................................................. 7
Lift Lockout/Tagout Procedure ........................................................................... 8
Operating Conditions .......................................................................................... 9
Approved Accessories ........................................................................................ 9
INSTALLER
: Please return this booklet to literature package and give to lift owner/operator.
© May 2014 by Rotary Lift. All rights reserved. CO9020
SPO15, SPO18
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
&
&
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
M
M
A
A
N
N
U
U
A
A
L
L
OM20169
Rev. F 5/2/14

Advertisement

loading
Need help?

Need help?

Do you have a question about the Sprinter SPO15 and is the answer not in the manual?

Questions and answers

Summary of Contents for Rotary Sprinter SPO15

  • Page 1: Table Of Contents

    Lift Lockout/Tagout Procedure ................8 Operating Conditions ..................9 Approved Accessories ..................9 INSTALLER : Please return this booklet to literature package and give to lift owner/operator. OM20169 © May 2014 by Rotary Lift. All rights reserved. CO9020 Rev. F 5/2/14...
  • Page 2: Safety Instructions

    Use only qualified INSTRUCTIONS INSTRUCTIONS lift service personnel and genuine Rotary parts to make repairs. • Thoroughly train all employees in use and care of lift, using manufacturer’s instructions and “Lifting It Right” and “Safety Tips”...
  • Page 3: Owner/Employer Responsibilities

    OWNER/EMPLOYER RESPONSIBILITIES The Owner/Employer: • Shall ensure that lift operators are qualified and that they are trained in the safe use and operation of the lift using the manufacturer’s operating instructions; ALI/SM07-1, ALI Lifting it Right safety manual; ALI/ST-05 ALI Safety Tips card; ANSI/ALI ALOIM-2008, American National Stan- dard for Automotive Lifts-Safety Requirements for Operation, Inspection and Maintenance;...
  • Page 4: Operating Instructions

    OPERATING INSTRUCTIONS Surface Mounted Frame Engaging Lifts To avoid personal injury and/or property damage, permit only trained personnel to op- WARNING erate lift. After reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift.
  • Page 5 SAFETY WARNING WARNING 5. While Using Lift: INSTRUCTIONS A. Avoid excessive rocking of vehicle while on lift. B. Always use safety stands as needed or when removing or Proper maintenance Remain clear of lift Keep feet and inspection installing heavy components. when raising or clear of lift is necessary...
  • Page 6: Maintenance Instructions

    • Daily: Inspect adapters for damage or excessive wear. maintenance procedures; STOP: Contact factory for in- Replace as required with genuine Rotary parts. structions. To avoid personal injury, permit only qualified • Monthly: Check equalizer cable tension. Adjust per lift personnel to perform maintenance on this equipment.
  • Page 7: Trouble Shooting

    TROUBLE SHOOTING Trouble Cause Remedy Motor does not run. 1. Blown fuse or circuit breaker. 1. Replace blown fuse or reset circuit breaker. 2. Supply correct voltage to motor. 2. Incorrect voltage to motor. 3. Repair and insulate all connections. 3.
  • Page 8: Lift Lockout/Tagout Procedure

    The responsibility for assuring that this procedure is followed is binding upon all employees and service personnel from outside service companies (i.e., Authorized Rotary Installers, contactors, etc.). All employees shall be instructed in the safety significance of the lockout procedure by the facility owner/manager.
  • Page 9: Operating Conditions

    OPERATING CONDITIONS Lift is not intended for outdoor use and has an operating ambient temperature range of 41º-104ºF (5º-40ºC). APPROVED ACCESSORIES Item Capacity Part Num- Air/Electric Utility Box FA5911 Air/Electric Utility Box Without FRL FA5910 Filter/Regulator/Lubricator (FRL) FA5166...
  • Page 10 NOTES...
  • Page 11 NOTES...
  • Page 12 Replacement Parts: See installers package for parts breakdown sheet. Order Genuine Rotary replacement parts from your nearest Autho- rized Parts Distributor. Maintenance Assistance: Contact your local Rotary distributor. Should further assistance be required, contact Rotary Lift, at one of the phone numbers listed below.

This manual is also suitable for:

Standard spo15Standard spo18Spo15Spo18