Sony BKS-R3202/R3210/R3220 Installation Manual page 57

Example : Destinations
. Satellite 1 connected to SDI routing switcher OUT 9
(SDI routing switcher given label destinations 001-032)
. DAT 1 connected to AES/EBU routing switcher OUT 9
(AES/EBU routing switcher given label destinations 033-048)
. Satellite 1 connected to Analog Audio OUT 9
(Analog audio routing switcher given label destinations 049-064)
Therefore :
SDI Satellite 1
AES/EBU
Analog Audio Satellite 1
If DAT001 destination is changed on a control panel only output label 41 (AES OUT 9) changes. Good
in situations where few signals logically follow from one level to the next (DAT's and cameras, Mics and
CG's, Audio Mixers and Still Stores, etc.). With this approach any sources/ destinations that should
follow across multiple routing switchers would require phantoms (covered later) to implement multiple
crosspoints switched.
A combination of virtual, and level mapping combines both approaches as shown in figure 6.
Level 1
Level 3
ROUTING SWITCHER SYSTEM (E)
(Sat001) ········· virtual level 1 out label 9
(DAT001) ······ virtual level 1 out label 41
(Sat003) ········· virtual level 1 out label 57
Virtural and Level Mapping
Fig. 6
4-4. Basic Setup Procedures
Level 2
4-11