Epson Rx-80/Lx-80 Printer Setup - Motorola R-2002A Manual

APPENDIX G
EPSON RX-80/LX·80 PRINTER SETUP
The optional RT-RX80/8148 printer as shipped by EPSON is configured for parallel operation. To use it with th
R2008D/R2010D, the 8148 serial interface card must be installed. Both the main PC board in the printer and the inter
face card have a series of DIP switches that must be set as follows:
DIP SWI
DIP SWI
l-1 off
1-2 off
1-3 off
1-4 off
1-5 off
1-6 on
1-7 on
1-8 on
1-1 off
1-2 off
1-3 off
1-4 off
1-5 on
1-6 off
1-7 off
1-8 off
Leave jumpers in factory set position.
Main Board
DIP SW2 2-1 on
2-2 on
2-3 off
2-4 off
8148 Serial Board
DIP SW2 2-1 on (off-parallel)
2-2 on
2-3 off
2-4 off
2-5 off
2-6 off
Note: If the printer is also to be used as a parallel printer for the R-1801A NAM application, DIP SW2-I on the 814
board may be brought out to an external toggle switch. In this case, leave SW2-l off.
These switch settings correspond to:
1200 baud, no parity, 8 bit word length
37