Motorola R-2002A Manual page 226

4) MANUAL TEST
The manual test mode is accessed by a '4' entry in the
'SEQ SEL' of the Signaling Sequence screen. See
figure 10. This mode allows the operator to enter and
send any one of the 43 commands to the transceiver
unit of the cellular telephone as defined by the AMPS
SPEC•of May, 1983.
A '3' entry in the Cellular Manual Test Mode accesses
the Cellular Manual Test display, which provides test
set up information (accessory cable kit part numbers)
for the various types of cellular units. See figure 11.
R2008D
R2010D
MANUAL TEST MODE CONNECTION.
The manual test mode requires that the R2008[
R20JOD seize control of the transceiver unit by rna
ing connection directly to the control pon on tl
mobile unit. The printer/junction box cable is co
nected to the 37 pin "D" connector on the rear panelc
the R2008D/R20JOD, and to the 50 pin "D" connectc
on the cellular junction box. The junction box is the
connected to the mobile with an adapter cable fro
either the RPX-4272A, RPX-42738 or RPX-4274
accessory kit. The antenna connector on the mobi
can be connected either to an external antenna fc
monitoring purposes, or to the R2008D/R2010
directly into the RF in/out port or via the variable R
tap for duplex measurements. See figure 9.
25 PIN CONNECTOR
(TO PRINTER)
01-80356A 73
JUNCTION
BOX
TO
POWER
SUPPLY
--+-USE APPROPRIATE CABLE
FROM RPX-4272
RPX-4273
RPX-4274
CELLULAR
RADIO
FIGURE 9. MANUAL TEST SETUP
11