Huawei Airbridge BTS3606E Commissioning Manual page 30

3 Commissioning Process
Operation Procedure
Step 1 Execute the command FTP ipaddress to log in to the BTS by using the following user name
and password:
Step 2 Execute the command PUT File.Path File.Name to download the specified software to the
BTS.
To load file bckm3606.bzp stored in drive D, execute the command PUT D:\bckm3606.bzp.
Step 3 After the loading is successful, execute the command LI ACT Boardname.Type to activate
the specified software.
To activate the CPU software of the BCKM, execute the command LI ACT bckm.cpu.
Step 4 Execute the command DSP CBTSBRDVER to check whether the activation is successful.
Step 5 If the activation is successful, repeat the steps 2 and 3 to activate all the BTS software.
----End
3-16
The loading of the BTS software does not affect the service.
The service is affected if you activate the BTS software.
When using the FTP to load software, you can load only one software module by
executing one command.
User name: system
Initial password: system
You can obtain the help information by executing the command LI ACT?.
The loading sequence is: CMTR/OMTR→CCPM/CECM→BCIM→BCKM.
For the loading of each board, you must load the FPGA before loading the CPU software.
To minimize the impact on service provision, you can load all the BTS software and then
activate the software in order when the traffic is low.
Huawei Technologies Proprietary
Airbridge BTS3606E&3606AE
System Commissioning Guide
Issue 02 (2006-10-10)