Wiring Diagram - Sharp WH-237DP Service Manual

1.6. If the control lamp is orange means that the water temperature is automatically controlled.
Illuminated : The water temperature will be controlled at the preset level.
Flash : Water fl ows too much and the warm water temperature is out of control.
If the incoming water temperature upward then press the
lamp will illuminate.
1.7. If the control lamp fl ash, the water volume knob should be reduced by turning the water volume
knob counterclockwise until the lamp stops fl ashing. (If the incoming water fl ows too much and
the warm water temperature is out of control then the control lamp will fl ash).
1.8. Bath a cold water by pressing the
The indicator will display OF and fl ashes 3 times. Press the
OF is fl ashing and OF (off) will stop fl ashing and the (orange) lamp will also be off.
2. Using the water volume knob.
Turn the button clockwise to increase water volume knob.
Turn the button counterclockwise to decrease volume.
3. Using the Power SW. button.
Press the button and the ELB lamp indicator will illuminate and water will fl ow from the shower
head, press the button again to turn off the heater.
temperature button until the temperature is lower then 32

WIRING DIAGRAM

5
temperature button and the control
temperature button again when
o
C.