Sharp WH-237DP Service Manual page 13

REMOVE OF TRIAC
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect 3 lead wires from the triac.
3. Remove 2 screws holding to the heater tank ass'y.
4. Now the triac is free.
White lead wire
Breaker lead wire
Brown lead wire
Triac lead wire
Screw
Triac
Heater tank
Fig. 24
REMOVE OF REED SWITCH
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect reed SW. lead wires from the PCB-1.
3. Remove 2 screws holding the reed SW. from the body valve.
4. Now the reed SW. is free.
Note : Tighten the mounting screws of the reed switch at the specifi ed torque ; 3-4 kgf.cm.
Screw
Reed SW.
Reed SW. lead wire
Body valve
Fig. 25
13