Kenwood TK-7180H Service Manual page 56

Controls
Power Volume
switch Up/Down key
Modular Programmable
MIC jack function keys
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press and hold the [A] key while turning the transceiver
power ON. Before the transceiver enters test mode, the
frequency version information appears on the LCD mo-
mentarily. Test mode can be inhibited by programming. To
exit test mode, turn the transceiver power OFF. The follow-
ing functions are available in test mode.
■ Key operation
"]" not appears *1
Key
Function
[S] Shifts to Panel tuning mode
[A] Function on
[B] MSK 1200bps and 2400bps
[C] Test signaling CH up
[ ]/[ ] Test frequency CH up/down
[ ]/[ ] Volume up/down
[ ] Squelch on/off
[■ ] Narrow/Wide
Microphone key
[PTT] Transmit
[0] to [9] Use as the DTMF keypad.
and [A], If a key is pressed during
[B], [C], transmission, the DTMF
[D], [#], corresponding to the key
[ ] that was presses is sent.
*
ADJUSTMENT (TK-7182H)
Channel
LCD Up/Down key
Display
-
"]" appears *1
2400bps : icon appears
Signaling No.
Channel No.
-
Narrow : "N"
Wide : "W"
-
-
TK-7180H/7182H
"]" appears *1
Key
Function
[S] High power / Low power
[A] Function off
[B] Compander on/off
[C] Beat shift on/off
[ ]/[ ] Function off
[ ]/[ ] Function off
[ ] Squelch level 0
[■ ] LCD all lights
Microphone key
[PTT] Transmit
[0] to [9] Function off
and [A],
[B], [C],
[D], [#],
[ ]
*
Note :
If a [S], [A], [B], [C] key is pressed during transmission, the
DTMF corresponding to the key that was pressed is sent.
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• LCD display in panel test mode
N 1
N : Narrow
W : Wide Channel No.
*1 : "]" appears at the position as shown in figure below.
Display
Low : icon appears
-
On : icon appears
On : icon appears
-
-
On : icon appears
LCD all point appears
-
-
1
–
Signaling No.
55