Led Indication - FUTABA R6208SB Manual

Operation Mode Select
The operation mode is on "Normal mode" from factory
shipping. When to change the mode, please follow the steps
shown below.
1
2
Press and hold the Link/Mode switch and turn on the
receiver. Keep the switch hold more than one(1)
LED
status.
3
Release the switch.
4
By doing this step, the mode can switch over between two(2)
modes.
0 sec.
Press and Hold
Function
Showing the CURRENT
mode with blink.
Red Blink = Normal
LED Status
Green/Red Blink =
High Speed
Please check the operation mode by observing the LED when
turning on the receiver. If possible there's no FASST transmitter
turned on around you in order to make firmer check.
When turn on the receiver, the LED will be;
If there are some FASST transmitter turned on around the
receiver, the LED may show the above status for a brief
moment then changed to the status indication as shown in the
"LED indication" table.

LED Indication

Red
Solid Solid Initializing
Off Solid
Solid Off Receiving signals
Blink Off Receiving signals but ID is unmatched
Link to the transmitter
1
Press and hold the Link/Mode
seconds.
Re-adjust the F/S position (only for TM-8)
1
Press and hold the Link/Mode switch between one(1)
0 sec.
0 to 1 sec.
Press and Hold
With TM-8
No function
(not included in this set)
Other than TM-8
(not included in this set)
1M23N17434
Turn on the receiver.
1 sec.
0 to 1 sec. More than 1 sec.
To change the mode between
No function
Normal and High Speed
Solid as the mode changed.
Red Solid = Normal
Green/Red Solid = High
Speed
(Become Red after one (1)
second)
Status
1 sec. 2 sec.
1 to 2 sec. More than 2 sec.
To set the F/S Re-link(ID set) and to
position(No re-link) set the F/S position
No function Re-link(ID set)
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
WARNING
motor's main wire is connected or the engine is
operating as it may result in serious injury.
While the linking is done, please cycle receiver
really under the control by the transmitter to be linked.
S.BUS Servo Channel Setting Method
S.BUS servo channel setting can be performed at the R6208SB
receiver.
1
the receiver.
* Connect the short-plug to the DATA port only when an S.BUS servo
channel is set. Normally do not connect the plug.
2
output connector(1 to 8) corresponding to the channel
you want to set.
Output
connector
* Channel setting mode A (ch1 to 8 setting mode) or channel setting
mode B (ch9 to 16 setting mode) can be set.
3
* At once when turning on the receiver, the channel setting is com-
pleted in mode A.
the red and green LED starts to blink simultaneously.
* The LED corresponding to the setting mode blinks.
Mode A: Red blinks 3 times
Mode B: Green blinks 3 times
4
FUTABA CORPORATION
Short-plug
(accessory)
S.BUS servo to the conventional system
Mode A
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
©FUTABA CORPORATION
DATA
9
10
11
12
13
14
15
16
Link/Mode button until
2010, 10 (1)