Advertisement
Quick Links
R7008SB
1 2
1
Thank you for purchasing a Futaba R7008SB FASSTest-2.4GHz compatible receiver. The R7008SB receiver features bi-directional communication
with a FASSTest Futaba transmitter using the S.Bus2 port. Using the S.Bus2 port an impressive array of telemetry sensors may be utilized. It also
includes both standard PWM output ports and S.Bus output ports.
Applicable systems: Futaba FASSTest-2.4GHz system transmitter
Usage precaution
12CH mode.
transmitters.
WARNING
cuits.
Antenna installation precaution
(Antenna installation)
90˚
Please refer the table below for LED status vs
receiver's condition.
LED Indication
Green
Red
Off
Solid
No signal reception
Solid
Off
Receiving signals
Alternate blink
Unrecoverable error (EEPROM, etc.)
Compliance Information Statement
(for U.S.A.)
This device, trade name Futaba Corporation of America, model number
R7008SB, complies with part15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
(3) This module meets the requirements for a mobile device that may be used
at separation distances of more than 20cm from human body.
To meet the RF exposure requirements of the FCC this device shall not be co-
located with another transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: support@futaba-rc.com (Support)
FASSTest-2.4GHz Bidirectional Communication System
S.BUS2 / S.BUS Port and 8 Channels for Conventional System Receiver
It connects with the
＋
battery for power, etc.
External voltage input
cable of an option is
used. The voltage of
the battery can be
displayed with a
transmitter.
Status
Antenna installation for carbon fuselage
WARNING
-
−
FASSTest-2.4GHz system(18CH/12CH mode)/S.BUS2 and S.BUS port
and 8 channels for conventional system receiver
al antenna diversity
i e
8
1 8
ei ht
8 o
o er re
irement
attery /
olta e t sets p ith a transmitter
tra olta e port
e s re that hen sin
meet yo r sa e condition
(Typical installation)
in (2
1
(1
)
to
( olta e ran e
C
∼
Cs re
lated o tp t the capacity of the
-
mm)
to 8
)
C m st
Advertisement
Related Manuals for FUTABA R7008SB
Summary of Contents for FUTABA R7008SB
-
Page 1: Led Indication
Thank you for purchasing a Futaba R7008SB FASSTest-2.4GHz compatible receiver. The R7008SB receiver features bi-directional communication with a FASSTest Futaba transmitter using the S.Bus2 port. Using the S.Bus2 port an impressive array of telemetry sensors may be utilized. It also includes both standard PWM output ports and S.Bus output ports. - Page 2 Channel Modes Easy Link ID allows FASSTest receivers to link to compatible The R7008SB is capable of changing its channel allocations as described transmitter without pressing the link button on the receiver. in the table below. This is especially important when using the receiver in a dual receiver mode.
Need help?
Do you have a question about the R7008SB and is the answer not in the manual?
Questions and answers