Tynetec Advent XT2 Installation Manual page 8

6. SYSTEM OPTIONS
Part No. Description
ZXT900 Advent XT2 Controller
ZXT901 Advent XT2 PA Amplifier
ZXT902 Advent XT2 External Battery Box
ZXT905 Manager's Display Panel
W07485 5 Port Ethernet Switch
ZXT920 Standard Intercom + PA
ZXT930 Door Entry Intercom + PA
ZXT931 Door Entry Intercom + PA + Bluetooth
ZXT940 Manager Callpoint
ZXT941 Custom Engraved Callpoint
ZXT942 Lift Callpoint (Flush S/S)
ZXT943 Custom Engraved Lift Callpoint (Flush S/S)
ZXT944 Lift Callpoint (Surface ABS)
ZXT925 Intercom I/O Expander
ZXT935 Bluetooth Remote Control
S00600 Ceiling Pullcord with 24V LED Reassurance
N/A Smoke Detector
N/A PIR Movement Detector
A00557 24V-12V Regulator Board
ZXT910 869MHz Network Receiver inc Antenna
ZXT8xx 869MHz Telecare Devices
ZXT950 Digital Door Panel + Manager Button
W00525 12V/2A Power Supply Unit
ZXT955 Door Entry Telephone
REMOTE CONTROL CENTRE (PSTN ARC)
The PSTN alarm receiving centre must support BS8521 or TT92 protocol. The Advent XT2 can have 2 dedicated PSTN
telephone lines connected, this will allow 2 simultaneous offsite calls or if one line fails the second line will
automatically be selected.
DIGITAL COMMUNICATOR (IP ARC)
The ARC must support Now IP protocol. A Broadband connection with a fixed IP address is required.
MANAGER'S DISPLAY PANEL
A maximum of 32 Manager's display panels can be connected on the Advent XT2 system. These are wall mounted
10.1" TFT touch screen monitors to display call information and the system status, they are also used to setup system
features and to add/remove radio devices. A large screen "Notice Board" monitor can be connected to the HDMI port
of each Manager's panel to display information on events or messages for staff/residents. Manager's panels require a
local mains supply and connection to the Advent XT2 controller via an Ethernet switch.
NETWORK RECEIVERS & TELECARE DEVICES
A maximum of 32 x 869MHz network receivers can be connected on the Advent XT2 system. Up to 8192 x 869MHz
Telecare radio devices can be registered per site (16 per dwelling). Radio devices include; personal pendants, fall
detectors, flood detectors, temperature sensors, gas detectors, CO detectors, etc.
DOOR ENTRY OPTION
Up to 16 digital door entry panels can be connected on the Advent XT2 system - additional PSU's will be required for
door locks. Door panels have a "Manager" button as standard, door entry telephone or intercom options are available.
PA OPTION
A public address (PA) option is available to broadcast general announcements or a fire alarm tone through all
intercoms. All intercoms have a PA facility as standard, one PA amplifier is required for every 80 intercoms. Each group
of 80 intercoms must be wired on a separate network leg.
Notes
includes power supply & standby batteries
maximum 80 PA intercoms per PA Amplifier
optional for XT2 Controller (24 hour battery standby)
maximum 32 per system
for up to 4 Manager's Panels (larger switches available)
255 network nodes as standard, this can be increased to 512 if
the second RS485 databus is connected.
Intercoms, callpoints, network receivers and door panels are
all network nodes.
Intercoms can connect ceiling pullcords, smoke detectors, PIR
detectors and up to 4 additional programmable inputs as
standard.
1 per intercom for additional 6 inputs + 6 outputs
optional for use with ZXT931 door entry intercom
Use normally open contacts - maximum 5 per intercom with
LED connected (no limit without LED)
use mains powered smoke detectors with integral
rechargeable standby battery & normally open relay output
use 12V DC PIR's with normally closed relay output (a 24V-12V
regulator board will be required in each intercom)
1 per intercom for PIR 12V supply
maximum 32 per system
maximum 8192 per system
maximum 16 per system
1 per door panel (for lock supply)
maximum 2 per intercom (master & extension)
Doc No. FM0804 issue 4 Page 8