Figure 3-3. Cpu Module Attached To Vxi/Vmepc-650 - National Instruments VXIpc 600 Series User Manual

Chapter 3 Configuration and Installation
VXI/VMEpc 600 Series User Manual
One of the user-configurable jumpers, W20, is located on the CPU module
attached to the base board. Figure 3-3 shows the location of the W20
jumper, which controls the system CMOS setting. Notice that you do not
have to remove the CPU module from the base board to configure any of
the jumpers on either board. Refer to the
chapter for more information.
1 Serial Number

Figure 3-3. CPU Module Attached to VXI/VMEpc-650

System CMOS
2 Assembly Number
3-4
section later in this
1
2
3
3 W20
© National Instruments Corporation