Rear Axle System: Adjustment - Renault Laguna III Manual

Rear axle system: Adjustment

4-WHEEL STEERING
Tightening torquesm
nut of the stub axle car-
rier while holding the
eccentric
nut of the steering con
rod while holding the
eccentric
Note:
Throughout the axle assembly checking and adjust-
ment process:
- the Renault Card must remain in the reader,
- do not press the « START » button.
ADJUSTMENT
I - ADJUSTMENT PREPARATION OPERATION
a Check the geometry of the axle assemblies (see
30A, General information, Axle assemblies:
Check, page 30A-19) .
GENERAL INFORMATION
190 N.m
90 N.m
II - REAR AXLE ADJUSTMENT
1 - Camber adjustment
a
IMPORTANT
Wear protective gloves during the operation.
a Undo the stub axle carrier upper nut (1) .
a Adjust the camber angle using the eccentric bolt (2)
according to the values measured at the time of the
check.
a Torque tighten the upper nut of the stub axle carri-
er while holding the eccentric (190 N.m).
a Check the camber values.
30A-32
30A
128647