Advertisement
2. Attach the hook to one side of the lower handle bar
using 1 hex bolt, 1 spacer, and 1 nyloc nut. Repeat for
the other side
(Figure
Note: Refer to
Figure 2
the bolts, spacers, and nuts.
3. Slide the axle spacer (300 mm) onto the axle
4. Place 1 axle spacer (25 mm) and 1 plain washer into
each wheel. Slide the wheels onto the axle.
5. Attach the axle to the undercarriage using 4 washers, 2
hex HD bolts, and 2 nuts.
Note: Keep the wheels on the inside of the
undercarriage
(Figure
6. To transport the machine, lift the unit up and latch the
hooks onto the top crossbar of the lower handle bar.
2).
for the correct orientation of
(Figure
2).
Operation
Note: When mowing, ensure that the transport wheel kit is
secured to the lower handle bar with both hooks.
Use the transport wheel kit to safely transport the machine
2).
from one location to another.
1. Shut off the engine, then release the hooks from the
lower handlebar, allowing the wheels to touch the
ground.
2. Lower the upper handlebar down far enough for the
deck to clear the ground.
3. Push the machine to the next desired location. To
continue mowing, secure the hooks back up on the
lower handle bar.
Maintenance
WARNING
Improper maintenance, using nonconforming
replacement components, or removing or modifying
any component may cause death or serious injury.
Do not modify any components of the kit or replace
any parts.
Ensure that all moving and pivoting parts are sufficiently
lubricated and regularly serviced.
2
Advertisement
