Table of Contents
Advertisement
EN
4. Lock the fence locking lever (37) (step 4).
Uninstall:
1. Unlock the fence locking lever (37).
2. Slide the fence (13) to the end of the slot and remove it from the slot.
05
Replacing saw blade (Fig. D, E, F)
WARNING! Always use saw blades according to the intended use!
using new saw blades!
Use only saw blades for which the maximum possible speed is not less
than the maximum spindle speed of the product.
Attachments are sharp and hot after use! Handle them with care! Wear
safety gloves when handling attachments to avoid injuries like burns and
cuts!
The rotation direction arrow on the saw blade (34) should comply with the
Follow these steps for replacing a worn or damaged saw blade:
1. Open the lower retractable blade guard (32) by hand to expose the locking screw
(33a) of the guard mounting plate (33) (Fig. D step 1).
2. Loosen the locking screw (33a) with the provided multi tool (7) (Fig. D step 2)
until the guard mounting plate (33) can be slid to the side (Fig. D step 3). For
EMIS216S, press down the operating handle (1) to help sliding.
3. Press the spindle locking button (26) fully and hold it in position. (Fig. E)
4. Turn the clamping screw (34a) slightly with the provided multi tool until the spindle
is locked.
5. Loosen the clamping screw (34a) clockwise and remove it together with the washer
the spindle (34d) (Fig. F).
6. Place a new saw blade on the spindle and make sure that the bore of the saw
guard (30).
22
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EMIS216S and is the answer not in the manual?
Questions and answers
laser light is on but not showing on timber why
The laser light on the Erbauer EMIS216S may not be showing on timber due to several reasons:
1. Laser Misalignment – The laser guide may need adjustment to properly align with the cutting area.
2. Obstruction – Dust or debris on the laser lens can block the light. Cleaning it may resolve the issue.
3. Power Supply Issue – The laser may not be receiving power due to a loose connection or a faulty switch.
4. Ambient Lighting – Bright lighting conditions may make the laser difficult to see on the timber surface.
5. Defective Laser Unit – If the laser is damaged or faulty, it may require repair or replacement by the manufacturer or an authorized agent.
Checking these factors can help identify and resolve the issue.
This answer is automatically generated