Dispensing A Treatment; Accessory Usage Conditions; Preparation For Use - Acteon Cube LED User Manual

5 Dispensing a treatment

5.1 Accessory usage conditions

The accessories and the handpiece must be cleaned, disinfected and sterilised before use.
Refer to the cleaning, disinfection and sterilisation protocols for accessories listed in the chapter Associated
documentation page 3.

5.2 Preparation for use

To prepare your medical device, follow the steps below:
1. Wear safety goggles and protective gloves.
2. Clean the unit with an alcohol disinfectant wipe.
3. Remove the handpiece from its sterilisation bag.
4. Remove the wrench from its sterilisation bag.
5. Remove the tip from its sterilisation bag.
6. Connect the cord and handpiece assembly to the connector on the control unit panel.
7. Install the irrigation line.
8. Install the irrigation bag.
9. Screw the tip onto the handpiece, first manually and finishing with the wrench.
10. Place the handpiece on its support.
11. Switch on the medical device.
12. Check the irrigation parameters depending on the tip chosen.
13. After water drainage, check that the spray works correctly.
Your medical device is now ready to use.
User Manual | Cube LED | J28821 | V3 | (17) | 03/2018 | NO40EN030C - Page 11/27