Configuring Ethernet - Pfeiffer Vacuum TPG 361 Operating Instructions Manual

8. Go to the "Release Notes" tab.
9. Go to the "Manage Parameters" tab.
10. Go to the "Manage Firmware" tab.
11. Select the firmware.
12. Click on "Update".
13. If the update was not successful, repeat the procedure.
14. Go to the "Manage Parameters" tab.
15. Write the parameters back to the device.
6.3 Configuring Ethernet
The Ethernet Configuration Tool enables the configuration of the Ethernet interface using a PC. Addi-
tionally, you can assign a virtual series interface (COM) to an IP address. You an access the virtual
COM interfaces using every program that supports series interfaces (e.g. terminal program, LabView,
etc.). Depending on the protocol setting, communication with the device is either via the Mnemonic or
Pfeiffer Vacuum protocol.
– You will find the change log here.
– We recommend that you store the parameters here before performing an update.
– <Load from disk> (local file) or <Load from server> (server connection).
– After the update, the status message "Firmware successfully updated!" appears at the bottom
edge of the window.
Commissioning
33/72