Performing A Fpga System Test; Introduction; Installing The Usb-Blaster Ii Driver - Terasic DE10-Nano Getting Started Manual

Performing a FPGA System Test

4.1 Introduction

This chapter shows how to install the USB-Blaster II driver and download a FPGA SRAM Object
(.sof) file to your FPGA board.

4.2 Installing the USB-Blaster II Driver

The steps below outline the step-by-step process of installing the USB-Blaster II driver.
1. Connect your computer to the development board by plugging the USB cable into the USB
connector (J13) of DE10-Nan0-SoC. (connection shown in
2. Power up the board and open the device manager in Windows. You will find an unknown device.
3. Select the unknown device to update the driver software. The driver file is in the \<Quartus II
installation directory>\drivers\ usb-blaster-ii directory.
DE10-Nano
Getting Started Guide
July 25, 2017
Figure 4-1 Unknown device on device manager
Figure 2-3)
12
Chapter 4
www.terasic.com.tw