Related Manuals for Lippert Components Kwikee Revolution Step Series
Summary of Contents for Lippert Components Kwikee Revolution Step Series
- Page 1 Kwikee Revolution Step Series ® OWNER'S MANUAL (3010002262) Rev: 07.26.2018 Kwikee® Revolution Step Series Owner's Manual 3010002262...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Information Product Information General Service Notes Prior To Operation operation Step With Control Unit troubleshooting Step Test Procedure testing the Motor Disconnect the 2-Way Connector Between the Step Motor And the Control Unit testing the 4-Way Connector Maintenance Step Motor Assembly Lubrication Maintenance In A Salt Environment... -
Page 3: General Service Notes
All control units are equipped with an ignition override system. This system is designed so that the vehicle will not be driven with the step in the extended position. When the step is locked in the extended position (step lockout switch is in the ‘off’... -
Page 4: Operation
If the ground to the control unit is lost, either between the step control unit and the vehicle chassis (the long green ground wire) or between the vehicle battery and the ground (negative battery cable) the step will not function. Make sure the battery terminals and all wire connections are clean and tight. -
Page 5: Troubleshooting
Number 369243 (LCI®). If you need assistance, contact Lippert Components, Inc. Customer Service at 1-574-537-8900. Step Test Procedure Inspect the step for visible damage that might restrict the step operation. Obtain a 4-way pigtail connector Part Number 909306000 (Kwikee®) or Part Number 369243 (LCI®). - Page 6 Fig. 2 Fig. 3 Understep light (not available on 25 amp all step models) in-line Rocker fuse Switch Motor assembly 12 AWG green ground to step top 10 gauge to 10 gauge chassis ground Step Wiring minimum Two-way connector Automotive connectors 12 AWG green ground wire (not supplied) must be securely attached to...
-
Page 7: Testing The Motor
testing the Motor Do not leave the wires connected during this test once the step has cycled either in or out. Failure to remove the wires from the battery will burn out the motor voiding any warranty. Disconnect the 2-Way Connector Between the Step Motor And the Control Unit Connect the red motor wire to the positive battery terminal and touch the yellow motor wire to the negative battery terminal to extend the step. - Page 8 Note: Be sure to use the terminal with only the white wire. The reading should be 0 volts DC. If the voltage reading is more, the white wire is connected to 12 volts DC and should be cut. If you have additional questions or need more assistance, contact Lippert Components, Inc. Customer Service at 1-574-537-8900.
-
Page 9: Maintenance
Fig. 10 Fig. 11 Fig. 9 Fig. 12 Fig. 13 Fig. 14 Fig. 15 Maintenance Step Motor Assembly Lubrication Clean all mud, salt, and road grime from the step before lubricating. Lubricate all moving parts (bearings, pivot points, slides, clevis pin, and drive linkage ball) every 30 days with a good quality moisture and heat resistant penetrating grease. - Page 10 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Kwikee Revolution Step Series and is the answer not in the manual?
Questions and answers