Resetting Your Kevo System - Kwikset Kevo User Manual

removing a fob
In order to remove a Kevo fob from a fob-only system, you will need to reset
your lock to factory default settings. Press and hold the Reset button on the back
panel for 10 seconds until the lock beeps. All fobs associated with the lock will
be deleted from memory.
note:
If you lose a fob from a fob-only system, you will need to reset the lock to
delete the fob from memory.
enrolling the first fob after a factory reset
1. Push the Program button on the back panel.
2. Press the enroll button on the fob.
3. Hold the fob close against the back panel.
Once the Kevo lock beeps twice and the fob's LED turns solid green, the fob
has enrolled successfully. You may now perform the Kevo fob calibration
process on page 9.
Fob-and-Phone system
enrolling a fob
In a fob-and-phone system, you can enroll an additional Kevo fob with the help of the
Kevo app. Navigate to the "Enroll a Fob" section of the app, and follow the prompts to
enroll your new fob. Once fob enrollment is complete, you may perform the Kevo fob
calibration process on page 9.
removing a fob
If you need to remove a fob from your system, select the desired fob from within
the Kevo app and follow the app's instructions to remove it.
note: You must be within Bluetooth range of your lock to delete a fob from your
Kevo system through the app.

resetting Your Kevo system

If you wish to restore your Kevo lock to factory default settings and delete all
smartphones and Kevo fobs from memory, press and hold the Reset button on
the back panel for 10 seconds until the lock beeps.
note: Resetting your Kevo lock will delete all eKeys associated with the lock;
however, you will be able to send eKeys at no charge to anyone who previously
had an active eKey at the time of reset.
11