Kwikset Powerbolt 2 Programming Instructions

Touchpad keyless entry

Hide thumbs Also See for Powerbolt 2:

Powerbolt

Programming Instructions

A User Code is used to unlock the door while a Mastercode is a password for making changes to

the lock features.

START

First, we need to confirm your lock is "ready" to

be programmed.

To be sure, let's reset your lock.

Step 1:

Reset your lock to original settings

Make sure the lock is in the unlocked position.

Remove the battery cover.

Press and hold the "Reset" button for 5 seconds. You will hear 3 long beeps after

the 5 seconds is completed indicating the lock has been reset.

You will reset your User Code to 1-2-3-4

TIP

and Mastercode to 0-0-0-0 when the reset is

complete.

Interior of door

Touchpad Keyless Entry

Table of Contents

Need help?

Do you have a question about the Powerbolt 2 and is the answer not in the manual?

Page 1 Powerbolt Touchpad Keyless Entry Programming Instructions A User Code is used to unlock the door while a Mastercode is a password for making changes to the lock features. START First, we need to confirm your lock is “ready” to be programmed. To be sure, let’s reset your lock.
Page 2 Step 2: Step 2: Set locking and unlocking direction Set locking and unlocking direction Make sure the door is open and in the unlocked position. Press 0 – 0 – 0 – 0 – – 00 – Note: Each button represents two numbers (i.e. ONLY push the button once for 0). If you incorrectly enter the code, wait 10 seconds until you hear three beeps.
Page 3 Step 3: Test the Lock Make sure the door is open and in the unlocked position. Press The latch will extend fully to the lock position and end with one beep and the keypad will turn off. Enter 1 – 2 – 3 – 4 – The latch will retract fully in the unlock position and end with one beep and the keypad will turn off.
Page 4 Step 5: Program User Codes Make sure the door is open and in the unlocked position. Enter the default Master Code 0 – 0 – 0 – 0 – – 1 – Enter a 4 to 10 digit code and press The lock will beep twice and the keypad will flash Green.