Installation Of The Multilux Led Light Unit; Maintenance And Care Of The Multilux Led Light Unit; Safety Notices - juwel TRIGON 190 Instruction Manual

Installation of the MultiLux LED light unit

The water tightness can only be guaranteed if the tube holders
have been firmly connected to their sockets and we
recommend that you check this prior.
The MultiLux LED light unit may now be placed on the top
frame of the aquarium and connected to the power supply.
Then, attach the flaps and close the aquarium.
In that context, ensure that the top frame of the aquarium and
the guide rails of the cover hatches are free of foreign objects,
e.g. sand or gravel.

Maintenance and Care of the MultiLux LED light unit

The JUWEL Aquarium MultiLux LED light unit requires little
care and maintenance. Only clean the frame with a soft cloth
and warm water.
Changing the LED tubes:
In order to fault-free functionality of the light unit, it is absolutely
necessary to disconnect the power plug prior to replacing the
LED tubes!
Only reconnect the MultiLux LED to the power supply after
this!
1. Unscrew the tube holders and slide them over the LED
tube.
2. Remove the LED tubes from the fittings.
3. Prepare the new LED tube for use by sliding the tube
holders over the tube.
4. Insert the new LED tube into the fitting as shown in the
illustration. Check the correct position.
5. Screw the tube holders on tightly.
6. Switch the light unit back on.

SAFETY NOTICES:

• LED module – do not look into the light source! Risk Class 2
• Never stare directly into the source of light for any period of time as you will
otherwise risk damaging your eyes.
• Pull the power plug for each LED tubes replacement.
• The connection line may not be repaired. Always replace the entire light unit
in case of damage.
• Do not operate the light unit under water.
• Do not attempt to open the light unit or repair it in case of a malfunction! This
would endanger the water-tightness.
• The JUWEL LED tubes are coordinated with the electronic components of
the MultiLux LED light unit. Therefore, only use these LED tubes as original
JUWEL Aquarium spare parts.
Notice:
If a defect occurs on the MultiLux LED light unit, it switches itself off automatically.
If a replacement of both LED tubes does not make the light function again, we recommend that you purchase a new light unit,
which is available as a spare part.
12