Sailor 6081 Psu And Charger - Thrane&Thrane SAILOR 6110 Installation Manual

1.4 SAILOR 6081 PSU and Charger

Note
If you are using a different type of power supply than the
SAILOR 6081, you must install a voltage monitor.
The SAILOR 6081 PSU and Charger is used to supply power to the units in the
SAILOR 6110 GMDSS System. It has five DC outputs of 24 V DC to 31.5 V DC
(nominal 29 V DC) each and provides 300 W continuous (370 W peak). It also
has a 15 V DC output, which should be used to supply power to the
GMDSS Terminal through the CAN bus.
The SAILOR 6081 PSU and Charger provides automatic switch-over to a
connected backup battery if 115/230 VAC is not available. It also has a charger
function for charging the battery when 115/230 VAC is available. Note that a
backup battery is mandatory in the GMDSS System.
On the SAILOR 6006 you can read status information such as AC alarm,
backup battery status and other status information from the SAILOR 6081,
through the Ethernet connection.
For further information on the SAILOR 6081, see the manual enclosed with the
SAILOR 6081 [4].
SAILOR 6081 PSU and Charger
Chapter 1: Introduction
5