PEUGEOT 206 Manual page 115

BOOT LAYOUT (206 SW)
1. Grab handles and coat hooks
2. Coat hooks
There are six hooks to accommodate coats.
3. High load retaining net fastenings
The high load retaining net can be installed behind the front seats or behind the rear seat.
Open the covers of the corresponding upper fastenings.
Install one end of the metal bar in one of the two fastenings, compress the bar, then install the other end and release.
Secure the two net strap hooks behind the front seats, with the rear seat folded down, or in the stowing rings on the floor.
The rings are located directly below the corresponding upper fastenings.
Pull the two straps taut.
4. Hooks
There are two side hooks on which to hang light bags.
5. 12 V Socket for accessories
This is a 12 volt socket (lighter type) installed on the the rear left trim and supplied from the accessories position
(1st notch).
6. Storage nets
There are two nets (which cannot be removed) which can contain the luggage retaining net, a first aid kit etc.
7. Retaining straps
There are two straps for securing various objects: cans etc.
8. Load space cover
Note: release the rear seat back to make installation and removal of the load space cover easier.
To install it:
– position one end of the roller in one of the two supports,
– compress the opposite end of the roller and position it,
– release it to allow it to engage,
– unroll the cover as far as the boot pillars,
– insert the cover guides in the rails in the pillars.
To remove it:
– remove the cover guides from the pillar rails,
– return the cover into its roller, compress it and remove it from its support.
9. Stowing rings
There are eight stowing rings for securing the luggage retaining net: four on the rear seat back and four on the boot floor
(two of which are under the carpet, at the far end of the boot).
Warning triangle
The tailgate has a location intended for a warning triangle.
26-05-2003
YOUR 206 IN DETAIL
107