Siemens Sinamics G120P Operating Instructions Manual page 309
Converter cabinet units 110 kw - 400 kw
Hide thumbs
Also See for Sinamics G120P:
- Instruction manual (100 pages) ,
- Technical manual (98 pages) ,
- Hardware installation manual (94 pages)
Table of Contents
Advertisement
Setpoint
The setpoint is used to specify the motor speed as percentage of the complete speed range.
To change the setpoint, proceed as follows:
1. Turn the navigation wheel and select "Control".
2. Confirm the selection by pressing the navigation wheel.
3. The "Control" screen appears.
4. The "Setpoint" entry is already selected.
5. Press the navigation wheel to select the "setpoint" entry.
6. The "Setpoint" screen appears.
7. Turn the navigation wheel to change the setpoint.
8. Confirm the new setpoint by pressing the navigation
wheel. The setpoint is also changed when you press the
"Esc" key.
9. The "Control" screen appears.
10. Press the "Esc" key to return to the "Status" screen.
The setpoint can be changed using the IOP only when the
inverter runs in MANUAL operation. The setpoint is reset
when a switch is made from MANUAL mode back to AUTO
mode.
Backward
The Backward command changes the rotational direction of the motor from forward to
backward.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Operation
6.10 Operation with the IOP
309
Advertisement
Table of Contents
