Hotpoint RG8640W Quick Manual

Quick Guide
THANK YOU FOR PURCHASING A HOTPOINT PRODUCT
To receive more comprehensive assistance, register the
appliance on
www.hotpoint.eu/register
CONTROL PANEL
1. ON/OFF button
2. DRY ONLY button and indicator light
3. KEY LOCK button and indicator light
4. CLEANING ACTION button
5. CLEANING ACTION indicator lights
6. START/PAUSE button and indicator light
7. DELAY button and indicator light
8. DRYING button
9. SPIN button
10. TEMPERATURE button
11. WASH CYCLE SELECTOR KNOB
WASH CYCLE TABLE
Maximum load 8 kg
Power input in off mode 0.5 W / in left-on mode 8 W
Wash cycle
1 Daily Wash & Dry
2 Shirts Wash & Dry
3 Pre Iron
4 Steam Refresh
5 Cotton (2)
6 Synthetics (3)
7 Anti-Stain Quick
8 Anti-Stain
9 White
10 Eco Cotton
11 Coloureds
12 Ultradelicates
13
14 Fast **
Rinse
Spin + Pump out *
 Required dosage  Optional dosage
The cycle duration indicated on the display or instruction manual is an estimate based on
standard conditions. The actual duration may vary in relation to several factors, such as
the temperature and pressure of the incoming water, ambient temperature, amount of
detergent, load quantity and type, load balancing and any additional options selected.
1) Test programme in compliance with standard EN 50229 (Wash):
This cycle is designed for normally soiled cotton loads and is the most efficient in terms of
both electricity and water consumption; it should be used for garments washable at 60°C or
at 40°C. The actual washing temperature may differ from the indicated value.
Test programme in compliance with standard EN 50229 (Drying): select the 10 wash
programme and set the drying level to "A3", for both loads. The first drying cycle must be
carried out with the nominal load.
PRODUCT DESCRIPTION
1. Top
2. Detergent dispenser drawer
3. Control panel
4. Handle
5. Porthole door
6. Drain pump (behind the plinth)
7. Plinth (removable)
8. Adjustable feet (2)
.
(1)
60°/40°
Wool
2.
7.
8.
Before using the appliance carefully read the Health and Safety guide.
Before using the machine, it is imperative that the transport bolts are removed. For more
detailed instructions on how to remove them, see the Installation Guide.
Maximum
Temperature
spin
(r.p.m.)
Default Range
40 °C - 40 °C 800
40 °C - 40 °C 1000
– – –
– – –
40 °C - 60 °C 1400
40 °C - 60 °C 1000
40 °C - 40 °C 1200
40 °C - 40 °C 1400
60 °C - 90 °C 1400
60 °C - 60 °C 1400
40 °C - 40 °C 1400
30 °C - 30 °C 0
40 °C - 40 °C 800
30 °C - 30 °C 800
– – 1400
– – 1400
For all testing institutes:
2) Long cotton cycle: set programme 5 at temperature 40°C.
3) Long synthetics cycle: set cycle 6 at a temperature of 40°C.
*
By selecting the
**
If a drying cycle is also programmed, the machine will run a "wash+dry" programme lasting
45' and a 1kg laundry load.
DETERGENT DISPENSER DRAWER
Compartment *:
Do not insert detergent in this compartment.
1.
Compartment 1: Washing detergent (powder
3.
or liquid)
If liquid detergent is used, the removable plastic
partition A (supplied) should be used for proper
dosage.
4.
If powder detergent is used, place the partition
into slot B.
5.
Compartment
The fabric softener must not exceed the "MAX" level.
6.
! Use powder detergent for white cotton garments, for pre-washing, and
for washing at temperatures over 60°C.
! Follow the instructions given on the detergent packaging.
1
DISPLAY
10
11 9 8
Detergents and
Additives
Max.
Wash
Duration
load
(Minutes)
(kg)
1
3,0
 
2,0
 
1,5 – –
2,0 – –
8,0
 
4,5
 
4,5
 
5,0
 
8,0
 
8,0
 
8,0
 
1,0
 
2,0
 
3,5
 
8,0 –

8,0 –

cycle and excluding the spin cycle, the washer-dryer will drain only.
2: Additives (fabric softeners, etc.)
EN
4
2 5
3
7 6
Recommended
detergent
Fabric
softener Powder Liquid
2
–
 
–
 
– – –
– – –
  
  
–
 
–
 
  
  
–
 
–
 
–
 
–
 
– –

– – –
A
*
1
2