Settings - Epson TM-P20 Technical Reference Manual

Settings

Select from the menu list on the left to check or configure the settings.
Enable the time server when using a certificate. Otherwise, the printer's Stored Date/Time may not be
set correctly and the wireless LAN may be unavailable. If this happens, enable the time server, or ini-
tialize the Stored Date/Time from one of the following:
 EpsonNet Config
 EpsonNet Config (Web Version)
 Wireless module setup mode
You can check the printer's Stored Date/Time from the dynamic status sheet.
Information menu
You can check the settings as shown in the table below.
Menu
Basic Information
IPv4 Address
TCP/IP
DNS/DDNS
SNMP
Bonjour
Time Setting
Timeout
ePOS-Print
66
Administrator Name, Location, interface Card Model Name, MAC Address, Hard-
ware Version, Software Version, Model Name,
Communication Standard, Network Mode, SSID, Channel, Transmission Rate,
Access Point MAC Address, Signal Condition,
Printer Status
IP Address Settings (Acquiring the IP Address, IP Address, Subnet Mask, Default
Gateway)
Set Using Automatic Private IP Addressing (APIPA)
DNS Server Addresses (IPv4) Settings (Acquire DNS Server Address Automati-
cally, DNS Server Addresses)
Domain Name Setting (Acquire Domain Name Automatically, Fully Qualified
Domain Name, Register the Network Interface's Address to DNS Server)
Community (Read Only, Wellknown Community Name)
IP Trap (Trap1/2, Address, Community)
Bonjour (Disable/Enable)
Bonjour Name, Bonjour Printer Name, Location
Use Time Server
Time Server Address, Update Interval, Time Server Status
Print (LPR, RAW (Port9100))
Version, ePOS-Print (Disable/Enable), Device ID
Settings