To Set The Initial Value Of Tire Pressure - Suzuki VITARA series Owner's Manual

OPERATING YOUR VEHICLE
EXAMPLE
61MM0A232
3) Turn the indicator selector knob (1) left
or right to select "Tyre Press" and push
the indicator selector knob.
EXAMPLE
61MM0A233
4) The display shows current tire inflation
pressure.
3-89
NOTE:
• If the low tire pressure warning light
comes on, the information display will be
switched to "Type Press" display and the
corresponding tire pressure indication
blinks to alert you which tire(s) is(are)
low pressure.
• The display may not show the tire infla-
tion pressure for about 10 minutes after
the vehicle begins to move. This is
because the TPMS system learns the
tire inflation pressure within this 10 min-
utes. The display will show the tire infla-
tion pressure after 10 minutes passed.
• If you stop the vehicle and turn the igni-
tion switch to "LOCK" position or change
the ignition mode to "LOCK" (OFF), and
leave it for 20 minutes or more, tire pres-
sure will be reset and will be indicated as
0 kPa when the engine is restarted. In
this case, the current tire pressure indi-
cation will recover after driving for a
while. However, if any of tire pressures
has been detected as low pressure
before stopping the engine, the tire pres-
sure indication may not recover and may
be indicated as "---".

To set the initial value of tire pressure

EXAMPLE
(1)
61MM0A156
1) When the ignition switch is in "ON"
position or the ignition mode is "ON"
and the vehicle is stationary, push and
hold the indicator selector knob (1) on
the instrument cluster for more than 3
seconds to change the information dis-
play to the setting mode.
54P00-01E