DeWalt DXAEJ14CA Instruction Manual page 18

to 3 average sized tires before the battery must be recharged. Return
hose to the storage compartment after use.
IMPORTANT: Make sure the Jump Starter Power Button has been
turned off before attempting to use the unit as a Compressor.
WARNING – To reduce the risk of serious injury or property damage:
Follow all safety instructions found in the "Specific Safety Instructions
for Compressors" section of this instruction manual.
CAUTION – To reduce the risk of serious injury or property damage:
When the compressor is operated at a low PSI, the unit may start in
low and gradually rev up. When the compressor is operated at higher
PSIs, the unit may operate normally for several minutes, then rev down
for a few minutes before returning to normal operation. This feature
protects the unit from overheating during normal use. In any event, do
not operate compressor continuously for longer than 10 minutes, as
it may overheat. This could damage the compressor. If the compressor
must be operated for longer periods: every 10 minutes press the
Compressor Power Button to turn the compressor off, then restart
after a cooling down period of approximately 30 minutes.
INFLATING TIRES OR PRODUCTS WITH VALVE STEMS
1. Screw the Sure Fit nozzle onto the valve stem. Do not overtighten.
®
2. Press the Compressor Power Button. A beep will sound and the
backlit LCD screen will display the following:
The Compressor Icon will light and the Digital Display will alternately
show the flashing pre-set psi value (that was last set by the
compressor pressure control buttons) and the current pressure of
the item being inflated (which will light solid).
3. Press the " " and " " Pressure Control Buttons to set the desired
pressure from a range pre-set values (between 3 and 120), which
will display on the backlit LCD Screen. The unit will sound a beep
with each press of the buttons (holding the button speeds up the
upward or downward value selection). Once the desired pressure
has been entered, release the button and the flashing digital display
will show the new selected pressure, as follows:
The new selected value is now stored in the unit's memory until it
is manually reset.
4. Press the Compressor Power Button once more to begin inflating.
The Compressor Icon will flash and the digital display will only show
the current pressure value (which will light solid) to indicate the
compressor is activated. Monitor the pressure on the LCD Screen.
IMPORTANT NOTE: To interrupt during inflation, press the
Compressor Power Button again.
5. When desired pre-set pressure is reached, the compressor will
automatically stop.
6. Press the Compressor Power Button again to turn off the unit.
7. Unscrew and remove the Sure Fit
8. Allow the unit to cool, then recharge before storing away.
9. Store the compressor hose and Sure Fit
compartment.
17
nozzle from the valve stem.
®
nozzle in the storage
®