Contents Contents Recycling and disposal..... 12 Guarantee and customer Safety ..........3 service ........12 Action-related warnings ....3 Guarantee........12 Intended use ........3 Customer service......12 General safety information..... 4 Appendix ..........13 Notes on the documentation ..7 Troubleshooting ......
Safety 1 1 Safety ral heating installations and for hot water generation. 1.1 Action-related warnings Intended use includes the fol- Classification of action-re- lowing: lated warnings – observance of the operating The action-related warnings instructions included for the are classified in accordance product and any other system with the severity of the pos- components...
1 Safety Improper use of any kind is ▶ Do not use any electrical prohibited. switches, mains plugs, door- bells, telephones or other 1.3 General safety communication systems in information the building. 1.3.1 Installation by skilled ▶ If it is safe to do so, close the tradesmen only emergency control valve or The installation, inspection,...
Page 5
Safety 1 1.3.5 Risk of death from ▶ Do not alter the safety escaping flue gas devices in any way. ▶ Do not damage or remove If you operate the product with any seals on components. an empty condensate siphon, ▶...
Page 6
1 Safety ▶ Faults and damage should 1.3.13 Risk of material be immediately rectified by a damage caused by frost competent person. ▶ Adhere to the maintenance ▶ Ensure that the heating in- intervals specified. stallation always remains in operation during freezing con- 1.3.11 Risk of corrosion ditions and that all rooms are damage due to...
Notes on the documentation 2 2 Notes on the 3.2 Design of the product documentation 2.1 Observing other applicable documents ▶ You must observe all operating instruc- tions enclosed with the system compon- ents. 2.2 Storing documents ▶ Keep this manual and all other applic- able documents safe for future use.
4 Operation 4 Operation 8 DHW mode 10Heating flow tem- perature buttons 9 Heating mode 4.1 Starting up the product ) and 4.1.1 Opening the isolator devices Conditions: The competent person who installed 3.4 Description of the display the product will explain where the isolator devices are and how to handle them.
Operation 4 4.3 Filling the heating installation 4.4 Selecting the operating mode Caution. Note After every ignition, the product Risk of material damage due runs in "Heating + hot water" to heating water that is ex- mode. tremely calciferous or corros- ive or contaminated by chem- The button lights up when the op- icals.
4 Operation 4.7 Frost protection Conditions: Hot water temperature: < 50 ℃ – mode is shown on the display. 4.7.1 The product's frost protection Conditions: Hot water temperature: ≥ 50 ℃ function – mode is not shown on the The frost protection function switches on display.
Troubleshooting 5 6 Care and maintenance Conditions: If you are away from home for several days, With controller 6.1 Maintenance ▶ Program the number of days you will An annual inspection and biennial main- be away in the controller to activate the tenance of the product carried out by a frost protection devices.
(e.g. holiday), you dress that is provided on the back page, or should also close the gas isolator cock you can visit www.glow-worm.co.uk. and the cold water stop cock. 7.2 Permanently decommissioning the product ▶...
Appendix Appendix A Troubleshooting Fault Cause Remedy Building gas isolator cock closed Open the building-side gas isol- ator cock Building power supply switched off Switch on building power supply On/off button on product switched off Switch on the on/off button on the product The heating flow temperature is set Select the required operating...
Page 14
Appendix Fault Cause Remedy The display shows Fault Press the fault clearance key (Re- set) and wait for five seconds. If the fault persists, in- form a competent person. The display shows Low water pressure in the system Add treated water If the problem occurs again: In- and the pressure form the competent person...
Need help?
Do you have a question about the Energy 35 Store-A and is the answer not in the manual?
Questions and answers