Ezex Pressure Relief Settings - Transcend 365 miniCPAP Auto User Manual
Hide thumbs
Also See for 365 miniCPAP Auto:
- Quick manual (160 pages) ,
- User manual (58 pages) ,
- Manual (2 pages)
Table of Contents
Advertisement
TM
Transcend 365 miniCPAP Auto
User Manual
Page 27
Use the Right button to highlight and the Center button to select Ramp Duration in
minutes. Press the Up or Down buttons to change the duration from 0 to 45 minutes,
moving through increments of five minutes. Press the Center button to save your
selection.
EZEX Pressure Relief Settings__ _____________
The EZEX feature allows you to reduce pressure when you exhale for more comfortable
therapy.
Use the Up/ Down buttons to highlight EZEX, then press the Center button to adjust
settings. The EZEX settings adjust the amount of pressure drop on exhalation, so that
you can comfortably exhale while using your CPAP.
Push the Up or Down button to move the value from 0 to 3. A setting of 0 provides no
exhalation relief, 3 provides the greatest exhalation relief. Press the Center button to
save your selection.
Use the Left/Back button to toggle back through screen options or return to the Home
screen.
Mask/Tube Settings_______________________
These settings help you select the appropriate mask and tube for optimal CPAP
performance. Select the settings that apply for you. Use the Up/ Down buttons to
highlight the setting, then press the Center button to adjust settings. Use the Up/ Down
buttons to toggle through the setting options, then press the Center button to save
your selection.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 365 miniCPAP Auto and is the answer not in the manual?
Questions and answers
I have a red water droplet and !!! Heater Error !!! in red How do I find the code?
To resolve the red water droplet and "!!! Heater Error !!!" message on the Transcend 365 miniCPAP Auto:
1. Red Water Droplet:
- This indicates the humidifier is disabled due to a condition such as:
- Use of water other than distilled.
- Residue from previously used tap water.
- Corrupt water signal, likely from moisture inside the CPAP.
- Solution:
- Empty the reservoir and rinse thoroughly with distilled water.
- Refill with only distilled water.
- If issue persists, run the CPAP in Dry Mode to remove internal moisture.
- After drying, disconnect and reconnect the power source to reset the system.
2. Heater Error:
- This may appear together with the red droplet and indicates the humidifier heater is disabled.
- Solution:
- Follow the same steps as above to address possible moisture or water quality issues.
- If error continues, contact your medical equipment provider or customer service for further assistance.
Using only distilled water and keeping the system dry helps prevent these errors.
This answer is automatically generated