Configuring The Mini Field Agent; Preparing Mini Field Agent For Boot Up - GE Mini Field Agent Instructions For Installation And Configuration

Configuring the Mini Field Agent

Preparing Mini Field Agent for Boot Up

Power
Supply
Figure 3 • Mini Field Agent integration diagram
2094532-001 D 02 2018
Perform the following procedure to install and configure the Mini
Field Agent device for use in the Carestation Insights solution.
To prepare the Mini Field Agent for bootup, perform the following
steps:
Note The Mini Field Agent Network port has been pre-configured with the
IP address 192.168.101.2 and subnet mask of 255.255.255.0.
1. Connect the Mini Field Agent WAN Port 0 to the computer
ethernet port, using an ethernet cable.
2. Connect the Mini Field Agent LAN Port 1 to the Facility network
switch, using an ethernet cable.
3. Connect the Mini Field Agent to the power supply.
Computer
eth0
eth1
Capsule
Server
SBX
Facility
Network
Switch
5