Pre-Operation Check; Cleaning, Maintenance And Storage - Yamaha PW-SE Original Instructions Manual

I. Pre-operation check
WARNING
Be sure to perform the inspection before riding the bicycle.
If there is anything you do not understand or find difficult, please consult a bicycle dealer.
NOTICE
• If you confirm there is a fault, have your bicycle inspected at a dealer as soon as possi-
ble.
• The power assist mechanism consists of precision parts. Do not disassemble it.
Along with performing the regular inspection before riding the bicycle, also perform the fol-
lowing inspections.
No. Inspection item
1 Residual battery capacity
2 Installation status of the battery pack
3 Operation of the e-Bike Systems
J. Cleaning, maintenance and storage
NOTICE
Do not use high-pressure washers or steam jet cleaners since they can cause water seep-
age, resulting in property damage or malfunction of the Drive Unit or display unit or battery
pack. Should water get inside one of these units, have an authorized dealer inspect your bi-
cycle.
Caring for the battery pack
Use a moist, tightly-wrung towel to wipe off dirt on the battery pack. Do not pour water directly on
the battery pack, such as with a hose.
NOTICE
Do not clean the contacts by polishing them with a file or using a wire, etc. Doing so could
result in a fault.
Maintenance for the Drive Unit
NOTICE
Because a Drive Unit is a precision machinery, do not disassemble or exert any strong force
on it (for example, do NOT hit this product with a hammer).
Especially since the crank axle is directly connected to the inside of the Drive Unit, any
large damages inflicted on the crank axle may lead to failures.
Inspection contents
Is enough capacity left in the battery?
Is it properly installed?
Do the e-Bike Systems operate when you
begin moving?
47
35