Yamaha PW-SE Original Instructions Manual page 28

28
Lock-release ring Lock-release ring
6. See "Reading the charging status for battery pack", and
check that the battery charger is charging the battery
pack.
7. The battery capacity indicator lamps will light up one by
one until all four are on. Then, when charging is com-
plete, all of the lamps will go off.
8. Confirm that charging is complete, and then disconnect
the charging plug from the battery pack.
How to disconnect the plug (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
9. Place the cap on the battery pack's charging connec-
tor.
10. Mount the battery pack on the bicycle.
WARNING
• Do not touch charger contacts with metallic ob-
jects. Do not allow foreign material to cause short
circuit of the contacts. This could result in electric
shock, fire, or damage the battery charger.
• Periodically remove dust from the power plug.
Dampness or other issues could reduce the effec-
tiveness of the insulation, resulting in fire.
• Never disassemble or modify the battery charger.
This could result in fire or electric shock.
• Do not use with a power strip or extension cord.
Using a power strip or similar methods may exceed
rated current and can result in fire.
• Do not use with the cable tied or rolled up, and do
not store with the cable wrapped around the charg-
er main body. Cable damage can result in fire or
electric shock.
• Firmly insert the power plug and the charging plug
into the socket. Failure to insert the power plug and
the charging plug completely can result in fire
caused by electric shock or overheating.
• Do not use the battery charger near flammable ma-
terial or gas. This could result in fire or explosion.
• Never cover the battery charger or place other ob-
jects on top of it while charging. This could result
in internal overheating leading to fire.
40