Table of Contents
Advertisement
RRU3931E
Installation Guide
(1): Cable tie
l
l
Step 2 Tighten the cable tie, securing the label on the cable, and then cut off the extra part of the
cable tie, as shown in
Figure 1-65 Securing the label on the cable
(1): Cable tie
Issue Draft A (2016-03-30)
NOTE
You should use an outdoor cable tie with a appropriate width in outdoor scenarios (the default is black
cable tie with 3.6 mm or 0.14 in. width).
The position for banding the label is recommended from 20 mm to 100 mm (0.79 in. to
3.94 in.) away from the cable connector. Ensure the front of the label facing you and not
be covered.
In case of both ports of the cable connected have different silkscreen, both ends of the
cable should bind the port label on the two ends of cable. For example, in dual BTSs
cascading scenarios, one end of the cascading FE/GE cable is connected to LAN1 port
on BTS0, and the other end connected to WAN port on BTS1. At this point, both ends of
the cable should band two labels Micro BTS0 LAN1 and Micro BTS1 WAN. As shown
in
Figure
1-64, the distance between the two labels is recommended from 10 mm to 20
mm (0.39 in. to 0.79 in.).
Figure 1-64 Positions for banding labels
NOTE
You may change the positions for attaching labels in actual situations. For example, you can bind a label
where the cable is bent.
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2): Label
1-65.
(2): Cable
1 RRU3931E Installation Guide
(3): Cable
(3): Label
58
Advertisement
Table of Contents
