Maneuvrability Of The Appliance; At The End Of The Work - Toro 1725-TES Owner's And Operator's Manual

1. If you intend to use the spray system, operate the lever of pump control switch (8) on the control
handlebar.
ATTENTION: Pushing the lever (8) forwards starts the pump in intermittent mode (Fig.7).
ATTENTION: Pushing the lever (8) backward starts the pump in continuous mode.
2. Push the machine with the brush rotating from left to right or vice versa.
3. Immediately afterwards, push the machine in the same way but in the opposite direction, so that
about one quarter of the working width overlaps the previous one.
4. We recommend that you vacuum up the dirt-loaded foam at intervals with the aid of a vacuum cleaner
for liquids (optional solution tank kit).
ATTENTION: The first time an operator uses the machine, he/she should become familiar with the
movements to be imparted to the shaft in order to be confident enough with the directionality of
movement of the machine, and should therefore not operate the machine near people or
obstacles.
ATTENTION: Work in slow movements to the right and left, possibly moving back so that the
operator always stands on an area of the floor yet to be cleaned up.
ATTENTION: Keep the power supply cable behind the operator, taking care not to operate the
machine in its vicinity in order not to damage it.
ATTENTION: Do not insist too much on the same area so as to avoid damaging the floor, also in
function of the type of brush or abrasive floor pad chosen.
ATTENTION: If you need to work in tight spaces you can turn the control column to the vertical
position.
7
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Disconnect the plug (1) of the power supply cable (2) in the mains
supply socket (3) (Fig.1).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
1
ATTENTION: During this operation, do not rest your foot on
the appliance.
3. Tip the appliance back and take it to the maintenance
area and carry out all the procedures listed in the section
"RECOMMENDED PERIODIC
column "AT THE END OF THE WORK".
8

AT THE END OF THE WORK

3
1
2
2
MAINTENANCE" indicated in the
14 14
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
2. Turn the handlebar to the vertical position, press the uncoupling
lever (4) (Fig.2) and turn the handlebar to the vertical position
(Fig.3). When the handlebar is vertical, release the uncoupling
lever (4).
4
3
4. Once the maintenance work is finished take the appliance to the
designated machine storage place.
ATTENTION: Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact with it.
EN